Antenna space/specs

["Henk Uijterwaal \(RIPE-NCC\)" <]

Randy,

> > where can i get the specs for the roof space and cable run requirements?
> > this would be suitable for consumption by build type folk.  so i need
> > something approximating "3cm abs tube", drawing of the mounting pad, ...

I don't have a drawing in a computer readable format (yet), but we've
ordered mounting pads for our new antennas that look like:

  antenna
    |
    o      Screw
    |
    o      Screw
    |
 ---+---   Base plate

The base plate is 6x10 cm, with 4 holes at the corners (approximately 0.75
cm away from each corner).  The mounting pad is 14 cm high.  One can
loosen the screws and adjust the pad for wall mounting, like

  antenna
    |
    o--o--| wall

You can also mount it to a pole with U-shaped brackets and nuts.

The antenna is 8 cm high, 14 cm diameter.

The standard cable has a special connector on one end, about 1.75 cm in
diameter.  The antenna cable can be extended with standard cat-5 cable.

Henk


------------------------------------------------------------------------------
Henk Uijterwaal                    Email: henk.uijterwaal@localhost
RIPE Network Coordination Centre     WWW: http://www.ripe.net/home/henk
Singel 258                         Phone: +31.20.535-4414,  Fax -4445
1016 AB Amsterdam                   Home: +31.20.4195305
The Netherlands                   Mobile: +31.6.55861746  
------------------------------------------------------------------------------

A man can take a train and never reach his destination.
                                               (Kerouac, well before RFC2780).