[atlas] IPv4 Built-ins fail while IPv6 work

HI, 
That might be it. There was no default route configured on my Edgerouter. I have now triied to configure one.
At the moment netstat -rn does show a default route for IPv4.
I have restarted the probe, I assume it may take a little time for the measurements to show results.
What’s strange is is that it did work as a router for my home network. I think I forced the link to the ISP to be the route somehow.


Thanks,
	Paul


> On 26 Jun 2024, at 13:36, Michel Stam <mstam at ripe.net> wrote:
> 
> Hey Paul,
> 
> I did a quick look in the logs and noticed that the probe doesn’t seem to have a default route for IPv4, but it does for IPv6. Can you check to see if this is a possible cause?
> 
> Regards,
> 
> Michel
> 
>> On 26 Jun 2024, at 09:10, RIPE via ripe-atlas <ripe-atlas at ripe.net> wrote:
>> 
>> Hi,
>> My old hardware probe seems to have finally given up. So I installed a soft probe on my openwrt edgerouter-X, using the openwrt opkg packages.
>> That seems to work except for all the IPv4 built-ins.
>> I have a hurricane.net tunnel as my ISP ( Odido) is stuck in the past and does not provide IPv6.
>> The IPv6 built-ins all show data but the IPv4 ones show ‘No data available for the period’
>> 
>> From the shell I can ping the addresses used by the built-ins, the names also resolve.
>> 
>> Any idea what the cause could be ? Or how to find the cause.
>> 
>> 
>> Probe ID = 1008458
>> Running   OpenWrt 23.05.3, r23809-234f1a2efa
>> Package: atlas-sw-probe
>> Version: 5080-2
>> 
>> Regards,
>> 	Paul
>> 
>> 
>> -- 
>> ripe-atlas mailing list
>> ripe-atlas at ripe.net
>> https://mailman.ripe.net/
> 
>