[atlas] Replacing flash key

Identical situation with me as well.  Probe ID 26130.

I noticed a System Tag was added that says Hardware problem suspected.  Do 
you have that too Marat?

-- 
|-Karl U. Stanzick
|-Managing Director, MTDS
|-in morocco 080200MTDS
|-direct +212(0)537278811
|-mobile +212(0)661152688
|-14, rue 16 novembre
|-Rabat 10080 Kingdom of Morocco



On Thu, 19 May 2016, Marat Khalili wrote:

> Hello Karsten,
>
> I use DHCP. Probe did obtain IP-address, responded to pings and showed some 
> network activity, but status page on the ATLAS site reported it as 
> disconnected.
>
> --
>
> With Best Regards,
> Marat Khalili
>
> On 19/05/16 16:59, Karsten Thomann wrote:
>> Hi,
>> 
>> do you use static IP's for the probe without any dhcp?
>> My probe wasn't able to use the new USB key when it was attached to a 
>> network
>> without dhcp (waited over 12hours).
>> After it was connected to a port in another network with dhcp the probe
>> recovered with the new usb key after some time.
>> 
>> Kind regards
>> Karsten
>> 
>> Am Donnerstag, 19. Mai 2016, 16:52:18 CEST schrieb Marat Khalili:
>>> My V3 probe (26656) disconnected yesterday, simple reboots didn't help.
>>> Suspecting problem with USB key I first tried to replace it with a new
>>> one. I took bog standard Transcend JetFlash 350 8Gb right out of the
>>> wrapping and inserted it into a started probe 10 minutes after boot. Did
>>> not format the flash key or alter it in any way, because someone
>>> previously said that it is not necessary. Unfortunately, probe did not
>>> come up, and the flash key seems unchanged after approximately 1 hour
>>> wait. What should I do to switch to a new flash key? Also, did someone
>>> tried connecting HDDs/SSDs, shouldn't they work better?
>>> 
>>> (Probe did appear after I inserted previously used flash key into it,
>>> but I suspect problem will re-occur in the future, so I'd like to know a
>>> way to fix it more permanently.)
>>> 
>>> --
>>> 
>>> With Best Regards,
>>> Marat Khalili
>> 
>> 
>
>