[atlas] Replacing flash key

Hello Karsten,

I use DHCP. Probe did obtain IP-address, responded to pings and showed 
some network activity, but status page on the ATLAS site reported it as 
disconnected.

--

With Best Regards,
Marat Khalili

On 19/05/16 16:59, Karsten Thomann wrote:
> Hi,
>
> do you use static IP's for the probe without any dhcp?
> My probe wasn't able to use the new USB key when it was attached to a network
> without dhcp (waited over 12hours).
> After it was connected to a port in another network with dhcp the probe
> recovered with the new usb key after some time.
>
> Kind regards
> Karsten
>
> Am Donnerstag, 19. Mai 2016, 16:52:18 CEST schrieb Marat Khalili:
>> My V3 probe (26656) disconnected yesterday, simple reboots didn't help.
>> Suspecting problem with USB key I first tried to replace it with a new
>> one. I took bog standard Transcend JetFlash 350 8Gb right out of the
>> wrapping and inserted it into a started probe 10 minutes after boot. Did
>> not format the flash key or alter it in any way, because someone
>> previously said that it is not necessary. Unfortunately, probe did not
>> come up, and the flash key seems unchanged after approximately 1 hour
>> wait. What should I do to switch to a new flash key? Also, did someone
>> tried connecting HDDs/SSDs, shouldn't they work better?
>>
>> (Probe did appear after I inserted previously used flash key into it,
>> but I suspect problem will re-occur in the future, so I'd like to know a
>> way to fix it more permanently.)
>>
>> --
>>
>> With Best Regards,
>> Marat Khalili
>
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: </ripe/mail/archives/ripe-atlas/attachments/20160519/42735508/attachment.html>