This archive is retained to ensure existing URLs remain functional. It will not contain any emails sent to this mailing list after July 1, 2024. For all messages, including those sent before and after this date, please visit the new location of the archive at https://mailman.ripe.net/archives/list/[email protected]/

[ipv6-wg] IPv6 Only Network at RIPE 67

Previous message (by thread): [ipv6-wg] IPv6 Only Network at RIPE 67
Next message (by thread): [ipv6-wg] [training] RIPE NCC Webinars - new dates

Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Marco Hogewoning marcoh at marcoh.net
Wed Oct 16 15:09:58 CEST 2013

> F5 SSL/VPN client doesn't seem to work.
> It gets stuck while authenticating...

I also use it and ran into two problems, running it on 10.8.5

- if you explicitly switch off IPv4, it will authenticate but right away disconnect again.

My guess is that it is trying to install an IPv4 route, which is denied by the OS and cause it to drop the link

- With IPv4 enabled, it does connect and works fine but after 10 mins it panics about the connection being dropped

I haven't been able to fully debug, but I suspect that this has to do with the self-assigned IPv4 address on the interface. I think that the moment the OS tries again in obtaining an IP address, the IPv4 side of the interface gets cleared and that causes the client to think the internet connection went away.

Marco

Previous message (by thread): [ipv6-wg] IPv6 Only Network at RIPE 67
Next message (by thread): [ipv6-wg] [training] RIPE NCC Webinars - new dates

Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

[ ipv6-wg Archives ]