Recommendations for DNS

[Hans Niklasson <]

Greetings

A little late perhaps, but better late then never.
This is one of the actionspoints from RIPE-28, to present easy and short
recommendations for setting up a DNS.
I will be presenting this for the DNS WG on RIPE-29.
Any suggestions or remarks will be very welcomed.
Especially the times for the SOA records.


                              DNS recommendations.
 
 
By:
 
Hans Niklasson hasse@localhost
Amar Andersson amar@localhost
 
 
 
Scope: 
 
This documents act as a recommendation for configuring your DNS. This is
NOT a requirement, only a recommendation of things to think about when
setting up your DNS.
 
Purpose:
 
To decrease lame delegations and limit unecessary traffic due to resolving
problems, among other things.
 
 
Records:
-----------------------------------------------------------------------------
 
SOA      The address in this field must be a valid e-mail address to the
         administrator for the DNS.
 
Ex:
 
domain.xx.        3600    SOA     dns.domain.xx admin.domain.xx. 
 
 
SERIAL   Serial number should follow this format: YYYYMMDDXX 
         ( year.year.year.year.month.month.day.day.nr.nr ),
         where XX is the number of the latest update of the zone in the 
         same day.
 
Ex:
 
                  1998010101      ; serial
 
 
TTL      A good balance of this will reduce unecessary traffic between
	nameservers.
 
Ex:
 
                  28800   ; refresh (8 hours)
                  7200    ; retry (2 hour)
                  604800  ; expire (7 days)
                  86400 )  ; minimum (1 day)
 
MX       When pointing a domain to a mailserver/hostname, donīt forget to
         add a glue record ( A ) for this.
 
Ex:
 
domain.xx.        86400    MX      10 mail.domain.xx.
 
mail.domain.xx    86400    A       192.168.0.1
 
 
CNAME    Use this with percausion. It is *not* recommended to use a CNAME
         for a mailservers hostname, as this can cause resolving problems
         and mailloops.
 
A        A gluerecord can only point to an IP address.
 
 
 
PTR      This is used for reverse lookup of the IP address to a hostname
         within the zone. Make sure that your PTR records and A records
         match. For each A record there has to be a PTR record, and vice
         versa.
 
 
More tips:
 
Unecessary glue data:  
	
	Donīt add unecessary glue data about hosts that is not within the
	zone. This can cause resolving problems if the host changes IP
	address.
 
Ex:
 
domain.xx.        86400    MX      10 mail.server.xx.
 
mail.server.xx    86400    A       192.168.0.1
 
Trailing dots: 
	Donīt forget to add a "." at the end of the domain/
        hostname. If this is forgotten, this will make the DNS to add the
        domain name to the domain/hostname again. This will cause
	resolving problems.
 
Ex:
 
domain.xx.        86400    MX      10 mail.domain.xx.domain.xx.
 
Illegal characters: 
	
	Only a-z , 0-9 and - is valid to use. All other characters is
	illegal and can cause the resolving to fail.
 
 
General Points:
 
        Use the latest version of the DNS software for your platform.
        Check for updates regulary, as new versions has the latest
	solutions and information.
 
 
Additional reading and references:
 
        RFC1537 ( RFC1912 )
        ( Common DNS Operational and Configuration Errors )
 
        "DNS & BIND 2nd Edition" by Paul Albitz & Cricket Liu 
        from OīReilly & Associates Inc.
        
        ftp://ftp.ripe.net/internet-drafts/draft-ietf-dnsind-classless-
        inaddr-04.txt
        ( For reverse delegation methods for blocks smaller than /24,
        256 addresses )
 
        http://www.dns.net/dnsrd/
        ( DNS Resources Directory )


/Hans Niklasson

Email: hasse@localhost
-----------------------------------------------------------------
                SWipNet - The Swedish IP Network
		Netcom Systems AB